![]() | ![]() |
|
![]() |
|
|
|
||||||
| Some Details: Posted by EPIC SRT on 07-17-2010 (09:37 PM), last reply was on 08-05-2010 (11:25 AM). This thread has received 21 replies and been viewed 461 times. |
![]() ![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#11 |
|
Senior Member
Join Date: Mar 2010
Location: Oakley, CA
Age: 24
Posts: 756
|
What is that from? Looks like the bottom part of a 90s silverado...
__________________
^That.
|
|
|
|
|
|
#12 |
|
Senior Member
|
Tom: The device will be installed via a jack. I only need to jack up one side of the car to install. Taking my time to do it right shouldn't take but about 30-45 minutes to install. I have to double check when I get there, but I should be able to install at the hotel the night before and drive over to the air strip.
Tenderloin: Yeah, thought about the front grill, will most like try taping up the upper holes and seeing what it does, just have to be mindful of engine temps. GO-SRT-GO: Not sure on the temp, that remains to be seen. In March it was cool in the AM, but by afternoon it had warmed up to the low 80's. Even if near 100 (I sure the hell hope no where near that hot) the time between runs should allow for the engine to cool down a bit. You stage to a lane, shut down. When your lane is up to the grid, you power up, drive to the grid and then shut down again. When the person two in front you exits the start box for their run, you power up and drive to the start box. Here you can leave it running or power down until the person next to you (would have been one in front of you) gets half way down the track. Sounds complicated, but not really. Of coarse, you always just leave it running when you take off from staging. CarGuySkye: You sir are correct! It was just shy of a direct fit. |
|
|
|
|
|
#13 |
|
Senior Member
|
Post 1 Updated!!
__________________
If I told you your car was HOT! would you let me drive it like I stole it?? ![]() Video: http://www.youtube.com/user/InfiernoDelDiablo |
|
|
|
|
|
#18 |
|
Senior Member
|
Yeah definitely tape the whole front end up including all the hood seams. I think this will give you the most gains, and definitely will be good bang for the buck. Tape is cheap!
__________________
Grimlock 2003 Corvette Z06 |
|
|
|
|
|
#20 | |
|
Senior Member
|
Quote:
I hear people talk about taping the front end. Is there a high risk of overheating and damaging the engine when you do this?
__________________
|
|
|
|
|
![]() ![]() |
| Tags |
| driven, facia, finished, front, mile, mod, mojave, preview, sneak, test |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
Legend: Registered Users, Super Moderators, Moderators |
| Thread Tools | |
| Display Modes | |
|
|